Project 4 :Variations using masks and multi-colours

Further experimentation adding colour and using masks to develop prints: 

I used the additional prints carried out earlier as the base for printing successive layers using a variety of techniques, including: impressed texture, backdrawing and masking. Using a small sketch of the view from the studio window, I attempted to recreate the image using print.

I used tracing paper, I created a number of masks to add additional colour to emphasise the house gable end and the trees. I dropped water on the printing plate to vary the texture in the foreground, which added interest by was difficult for me to control.

I then covered all areas except the sky to allow me to balance the colour composition of the prints as some areas were too pale.

On some prints, I used backdrawing and imprinting with corrugated cardboard to build up the form of the houses.

Landscapes produced from layered colour ask and impressed techniques 

Reflections

I really enjoyed using these techniques. However I did find it difficult to create fine detail. However, the effects created by the printing process really added to the visual interest of the prints. For this reason, it was even more important to thoroughly plan the pieces as well as possible before starting printing.

Wome of the prints are quite well registered, but the addition of masks seemed to make this more difficult to achieve due to slippage of the sides of the masks. I tried taping these down with masking tape but ther was still some dragging across the print.

Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s